Products

FireHalt® Fire Protection Products

Recessed Luminaire Covers
FireHalt® Luminaire covers have been developed to provide maximum protection for ceilings where fire resistant tiles have been replaced by light fittings. These covers have been designed to allow for ease of fitting. The covers incorporate ventilation slots to reduce any potential build up of heat in the light fitting. In a fire situation the cover’s intumescent materials expand to close the slots with a highly insulating fire resistant char, preventing the fire from penetrating the ceiling.

Illustration of cover fitted to ceiling grid
The cover is unaffected by moisture and is non toxic. When the cover is in place, the modular light fitting can be installed as normal. The cover itself requires no maintenance and is easily removed for maintenance of the light fitting.
Fitting Instructions
  • Maintains the fire protection performance of the ceiling and prevents fire from penetrating the ceiling void
  • No Clips, screws, drilling or additional support required
  • Supplied as a flat pack. Simple to fix in minimal time (under 60 seconds).
  • No special training required.
  • Sizes to fit a wide range of modular fittings up to 1200 x 600mm
  • Cost effective

Step One:

Cut through the foil covering each slot. Place main section with foil covering side face down, Fold in sides A and B so they are at 90o to the roof. Ensure the roof of the cover sits completely on the sides of the cover.
 

Step Two:

Insert end sections C into slots of sides A and B ensuring foil covered side is on the outside of the cover.
Step Three:

 Place cover over light fitting using small slots to locate over the ceiling tracks. No clips are required. These slots have been designed so that the cover rests 15mm above the lip of the rail to allow for the fitting of the ceiling tile.
Step Four:

All electrical connections can be passed through the ventilation slots D and the light fitting can be installed as normal

FireHalt® Recessed Luminaire covers underwent a fire resistance test in a suspended ceiling void employing the general procedures and criteria of BS476 part 23:1987
Date of test: 19th July 2000

Certificate no.: TE200854

Duration of effective protection: 66 minutes

Test House: BRE

Saveguard UK Ltd, Tame Valley Mill, Wainwright Street, Park Road, Dukinfield, Cheshire SK16 5NB Tel 0161 344 2484 Fax 0161 344 2486

Electronic Mail:    sales@firehalt.com

Webmaster:    webmaster@firehalt.com


 Copyright © 2000 Firehalt (UK) Ltd. All rights reserved.
Revised: December 15, 2000